Title:
Flexural Improvement of RC Slabs by FRP or Steel Using Different Strengthening Systems and Novel Anchoring Techniques
Author(s):
Mohamed H. Makhlouf, Ibrahim A. El-Azab & M. H. Mansour
Publication:
IJCSM
Volume:
18
Issue:
Appears on pages(s):
Keywords:
Near-surface mounted (NSM), Flexure, Externally bonded embedded in concrete cover (EBECC), Externally bonded (EB), Innovative anchorage
DOI:
10.1186/s40069-024-00683-y
Date:
9/30/2024
Abstract:
An experimental study on reinforced concrete one-way slabs strengthened by various methods and materials is introduced in this paper. Innovative anchorage procedures are presented and evaluated to prevent the strengthening elements with FRP system from de-bonding at the initial stages. Externally bonded embedded in concrete cover (EBECC) strengthening technology was proposed to save the fiber strips from being subjected to heat, degradation, and sabotage. Nine RC one-way slabs, including a control slab and eight strengthened slabs, were cast. One RC slab was strengthened using externally bonded embedded in concrete cover (EBECC), whereas the other tested RC slabs were strengthened using either externally bonded (EB) or near-surface mounted (NSM) procedures. The following test variables are used in this study: the proposed anchors, the area of steel, the kind of material utilized in NSM rods (carbon fiber reinforced polymer (CFRP), glass fiber reinforced polymer (GFRP), and steel), and the strengthening scheme. The ultimate and initial cracking loads, load–deformation response, cracking patterns, and failure behavior were recorded and discussed. Additionally, a comparison of the stiffness, ductility, and energy absorption of the examined slabs was reported. The strengthened slabs by various techniques showed a boost in flexural strength that varied from 67 to 107% compared to the control slab. In addition, RC slabs strengthened by NSM-CFRP bars showed a maximum flexural capacity when compared with slabs strengthened by GFRP and steel bars. Also, the results supported the superiority of a novel end anchorage. The ABAQUS program was employed to conduct a finite element analysis (FEA) employing 3-D geometries to compare and assess the numerical performance of the identical slabs under similar test settings. The results showed good agreement between the experimental and numerical findings.