Table of Contents
Preface
Introduction
Section 1—General requirements
1.1—Scope
1.2—Requirements
1.3—Definitions
1.4—Referenced standards
Section 2—Materials
2.1—Reinforcing steel fabrication
2.2—Reinforcement location
2.3—Placement of embedded items, excluding dowels in slabs-on-ground
2.4—Concrete batching
2.5—Concrete properties
Section 3—Foundations
3.1—Deviation from plumb
3.2—Deviation from location
3.3—Deviation from elevation
3.4—Deviation from plane
3.5—Deviation from cross-sectional dimensions of foundations
Section 4—Cast-in-place concrete for buildings
4.1—Deviation from plumb
4.2—Deviation from location
4.3—Distance between adjacent elements sectioned by a
vertical plane
4.4—Deviation from elevation
4.5—Deviation from cross-sectional dimensions
4.6—Deviation from sawcut depth or formed opening width or height
4.7—Deviation from relative elevations or widths
4.8—Deviation from slope or plane
Section 5—Precast concrete
This section has been removed.
Section 6—Masonry
This section has been removed.
Section 7—Cast-in-place, vertically slipformed building elements
7.1—Deviation from plumb for buildings and cores
7.2—Horizontal deviation
7.3—Cross-sectional dimensions
7.4—Openings through elements
7.5—Embedded plates
7.6—Deviation from plumb for slipformed and jumpformed silos
Section 8—Mass concrete structures other than building elements
8.1—Deviation from plumb
8.2—Horizontal deviation
8.3—Vertical deviation
8.4—Cross-sectional dimension
8.5—Deviation from plane
Section 9—Canal lining
9.1—Horizontal deviation
9.2—Vertical deviation
9.3—Cross-sectional dimensions
Section 10—Monolithic water-conveying tunnels, siphons, conduits, and spillways
10.1—Horizontal deviation
10.2—Vertical deviation
10.3—Cross-sectional dimensions
10.4—Deviation from plane
Section 11—Cast-in-place bridges
11.1—Deviation from plumb
11.2—Horizontal deviation
11.3—Vertical deviation
11.4—Length, width, or depth of specified elements
11.5—Deviation from plane
11.6—Deck reinforcement cover
11.7—Bearing pads
Section 12—Pavements and sidewalks
12.1—Horizontal deviation
12.2—Vertical deviation of surface
Section 13—Chimneys and cooling towers
13.1—Deviation from plumb
13.2—Outside shell diameter
13.3—Wall thickness
Section 14—Cast-in-place nonreinforced pipe
14.1—Wall thickness
14.2—Pipe diameter
14.3—Offsets
14.4—Surface indentations
14.5—Grade and alignment
14.6—Concrete slump
Foreword to checklists
Mandatory requirements checklist
Optional requirements checklist