Table of Contents
Chapter 1—Introduction
1.1—Introduction
1.2—Discussion on design example problems
1.3—Commentary on seismic requirements for Appendix D of ACI 318-02 and ACI 318-05
1.4—Commentary on seismic requirements for Appendix D of ACI 318-08
1.5—Commentary on notation and definitions for Appendix D ACI 318-08
1.6—Anchor designs featured in example problems
Chapter 2—Notation and definitions
2.1—Notation
2.2—Definitions
Chapter 3—ACI 318-05 Appendix D (reprinted)
Chapter 4—Design examples
4.1—Example 1: Single headed anchor away from edges subjected to seismic tension
4.2—Example 2: Single hooked anchor away from edges subjected to seismic tension
4.3—Example 3: Single post-installed anchor in tension away from edges
4.4—Example 4: Group of headed studs in tension near an edge
4.5—Example 5: Single headed bolt in shear near an edge
4.6—Example 6: Single headed bolt in tension and shear near an edge
4.7—Example 7: Single post-installed anchor in tension and shear near an edge
4.8—Example 8: Group of cast-in anchors in tension and shear with two free edges and supplemental reinforcement
4.9—Example 9: Group of headed studs in tension near an edge with eccentricity
4.10—Example 10: Multiple headed anchor connection subjected to moment and shear
4.11—Example 11: Multiple post-installed anchor connection subjected to seismic moment and shear
4.12—Example 12: Multiple headed anchor connection subjected to seismic moment and shear
4.13—Example 13: Group of tension anchors on a pier with shear lug
Chapter 5—References
5.1—Referenced standards and reports
5.2—Cited references
Appendix A—Tables
Table A.1—Materials for headed anchors and threaded rods
Table A.2(a)—Bearing area (Abrg) for cast-in anchors,threaded rod with nuts, and threaded rods
with nuts and washers
Table A.2(b)—Dimensional properties of bolts and studs for determining bearing area (Abrg)
Table A.2©—Dimensional properties of nuts for determining bearing area (Abrg)
Table A.3—Sample data for a post-installed, torquecontrolled mechanical expansion anchor
Table A.4—Sample data for a post-installed, undercut anchor