Table of Contents
CHAPTER 1—INTRODUCTION AND SCOPE, p. 2
1.1—Introduction, p. 2
1.2—Scope, p. 2
CHAPTER 2—DEFINITIONS, p. 2
2.1––Definitions, p. 2
CHAPTER 3—PROJECT EVALUATION, p. 2
3.1—Condition assessment of concrete, p. 2
3.2—Moisture in and on concrete, p. 4
3.3—Concrete surface, p. 6
3.4—Previously applied protection systems, p. 7
3.5—Contamination of concrete, p. 8
3.6—Repair of nonstructural defects, p. 10
CHAPTER 4—METHODS OF SURFACE
PREPARATION, p. 11
4.1—Surface cleaning of concrete, p. 11
4.2—Abrasive blasting (wet or dry), p. 13
4.3—Abrading concrete, p. 13
4.4—Hydrodemolition, p. 15
4.5—Other procedures, p. 15
CHAPTER 5—EVALUATION OF SURFACE AFTER PREPARATION, p. 16
5.1—Minimum acceptable levels of preparation for various protection systems, p. 16
5.2—Surface profile, p. 16
5.3—Special concerns for system materials that depend on adhesives, p. 17
5.4—Special concerns for materials that depend on bond strength, p. 17
5.5—Special concerns for materials that depend on penetration, p. 18
5.6—Influence of ambient conditions on adhesion, p. 18
CHAPTER 6—QUALITY ASSURANCE AND QUALITY CONTROL, p. 18
6.1—Preinstallation conference, p. 18
6.2—Mockups, p. 19
CHAPTER 7—REFERENCES, p. 19
Authored documents, p. 20